|
Q: Is
it hard to install?
A: No!
Simply Attach the fence light to any wood post or t-post
(with optional bracket sold separately).
Run the ground wire either to a ground line on
fence or earth ground it.
Take the knocker and hang it over the hot wire on
the fence.
That is all there is to it!
Q: Do I
have to have a fence clear of weeds before I install my
fence light.
A: We
highly recommend it.
A fence that has weeds all over it defeats the
purpose of having a fence light unless the box has that
much output.
Every weed that grows and touches the fence lowers the
line voltage on the fence because the fencer is trying to
burn them off.
The light monitors the line voltage on the fence.
When the fence is loaded down with weeds then the
light is not
going to flash all the time, or in the worst case maybe
not at all.
That means that even if the box is showing you have output
voltage going to your fence, your actual fence lines do
not have enough voltage.
That is also not good for containing livestock.
Q:
Where on my fence do I have to install my fence light?
A:
Anywhere! The
electric fence light will monitor the condition of your
fence when installed to any part of the fence.
Q: Does
the light work without the knocker?
A: The
light will work without the knocker, however the light is
not designed to work without the knocker.
If the light is used without the knocker it will
draw a considerable amount of energy from the fence and
ground it out in some conditions.
Q: Does
the knocker work without the light?
A: Yes
Q: Do
you make a predator globe for the light?
A: We
currently are working on one.
Q: How
do I adjust my knocker?
A:
Instructions on how to adjust your knocker came with your
fence light.
If you have lost them, refer to the Knocker Air Gap
Adjustment link on the previous page.
Return
to Electric Fence Indicator Light Main Page
|
